Hyundai Tucson Quiz
Body Work (Interior and Exterior)

Front Seat Belt Pretensioner

In this manual: Body Work (Interior and Exterior)
General Information — 17Engine Mechanical System — 51Engine Electrical System — 26Emission Control System — 23Engine/Fuel Control System — 44Clutch System — 12MANUAL TRANSMISSION SYSTEM — 12AUTOMATIC TRANSMISSION SYSTEM — 42Four-Wheel Drive (4WD) System — 14Drive Shaft and Axle — 22Suspension System — 30Steering System — 16Restraint — 21Braking System — 47Body Work (Interior and Exterior) — 145Body Electrical System — 162Heating, Ventilation and Air Conditioning — 39
4steps
~24min
2/5difficulty
02040608010053.940N·mlb·ft
Tightening torque found on this page
Done 0 of 4

Components and Component Location

COMPONENT LOCATION

1. Front seat belt pretensioner

Repair Procedures

REPLACEMENT

  1. Remove the center pillar upper trim (Refer to page BD-60). (Refer to Interior Trim - "Center Pillar Trim")
  2. After removing the upper anchor bolt from the front seat belt, remove the front seat belt upper anchor (B).

    Tightening torque: 39.2 ~ 54 N·m

  3. Disconnect the connector (A) after loosening the mounting bolt, and remove the front seat belt pretensioner (B).

    Tightening torque: 39.2 ~ 54 N·m

  4. To install, perform the removal procedure in reverse order.
    1. Insert tool (A) vertically into hole (F). Then tilt it more than 10°, as shown in the illustration.
    2. Insert and press tool (B) vertically into hole (E). The seat belt anchor connector (D) is then disconnected.

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.