Hyundai Tucson Quiz
Braking System

Repair Procedures

In this manual: Braking System
General Information — 17Engine Mechanical System — 51Engine Electrical System — 26Emission Control System — 23Engine/Fuel Control System — 44Clutch System — 12MANUAL TRANSMISSION SYSTEM — 12AUTOMATIC TRANSMISSION SYSTEM — 42Four-Wheel Drive (4WD) System — 14Drive Shaft and Axle — 22Suspension System — 30Steering System — 16Restraint — 21Braking System — 47Body Work (Interior and Exterior) — 145Body Electrical System — 162Heating, Ventilation and Air Conditioning — 39
7steps
~42min
3/5difficulty
0102030405012.79N·mlb·ft
Tightening torque found on this page
Done 0 of 7

ITEM

ABS Air Bleeding. Strictly follow the procedure below to ensure proper air bleeding and filling of the ESC unit, brake fluid lines and master cylinder.
  1. Remove the reservoir cap and fill the reservoir with brake fluid.
  2. Connect a clear plastic tube to the bleeder valve on the wheel cylinder and insert the other end of the tube into a clear plastic bottle half filled with fluid.
  3. Connect the GDS to the data link connector located below the instrument panel.
  4. Select and use in accordance with the instructions displayed on the GDS screen.
    1. Select the vehicle model name.
    2. Select the ABS/ESC system.
    3. Select the HCU bleeding mode.
  5. Depress the brake pedal several times, then loosen the bleeder screw and wait until brake fluid flows out without air bubbles. Then tighten the bleeder screw (A). BEFORE
    REAR
  6. Repeat step 5 in the following order until fluid without bubbles flows from each wheel.
  7. Tighten the bleeder screw. Bleeder screw tightening torque: 6.9 ~ 12.7 N·m

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.