Hyundai Tucson Quiz
Braking System

Front Wheel Speed Sensor

In this manual: Braking System
General Information — 17Engine Mechanical System — 51Engine Electrical System — 26Emission Control System — 23Engine/Fuel Control System — 44Clutch System — 12MANUAL TRANSMISSION SYSTEM — 12AUTOMATIC TRANSMISSION SYSTEM — 42Four-Wheel Drive (4WD) System — 14Drive Shaft and Axle — 22Suspension System — 30Steering System — 16Restraint — 21Braking System — 47Body Work (Interior and Exterior) — 145Body Electrical System — 162Heating, Ventilation and Air Conditioning — 39
9steps
~54min
2/5difficulty
04080120160200107.880N·mlb·ft
Tightening torque found on this page
Done 0 of 9

Components and Component Location

COMPONENTS

1. Front wheel speed sensor cable 2. Wheel Speed Sensor Front

Repair Procedures

DEPOSIT

  1. Remove the front wheel and tire assembly (A) from the hub.

    Tightening torque: 88.2 - 108 N·m

  2. Remove the wheel speed sensor (B) from the front axle (A).

    Tightening torque: 8.8 - 13.7 N·m

  3. Remove the wheel speed sensor bracket.
  4. Remove the wheel speed sensor cable bracket bolt.

    Torque: 19.6 ~ 29 N·m

  5. Remove the front wheel arch liner.
  6. Disconnect the front wheel speed sensor connector, then remove the front wheel speed sensor.
  7. To install, perform the removal procedure in reverse order.

Inspection

  1. Measure the output voltage between the wheel speed sensor terminal and ground.
  2. Compare the change in wheel speed sensor output voltage with the normal output voltage change specified below.

    T_low: 0.59 V ~ 0.84 V, V_sup: 1.18 V ~ 1.68 V, Frequency range: 1~2500 Hz

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.