Hyundai Tucson Quiz
Heating, Ventilation and Air Conditioning

Blower Resistor (Manual) Repair Procedures

In this manual: Heating, Ventilation and Air Conditioning
General Information — 17Engine Mechanical System — 51Engine Electrical System — 26Emission Control System — 23Engine/Fuel Control System — 44Clutch System — 12MANUAL TRANSMISSION SYSTEM — 12AUTOMATIC TRANSMISSION SYSTEM — 42Four-Wheel Drive (4WD) System — 14Drive Shaft and Axle — 22Suspension System — 30Steering System — 16Restraint — 21Braking System — 47Body Work (Interior and Exterior) — 145Body Electrical System — 162Heating, Ventilation and Air Conditioning — 39
7steps
~42min
2/5difficulty
Done 0 of 7

Inspection

  1. Measure the resistance between the terminals.
  2. If the measured resistance is not within specification, replace the blower resistor. (After removing the resistor)

REPLACEMENT

  1. Disconnect the negative (-) battery terminal.
  2. Remove the center instrument panel. (Refer to Body - "Center Instrument Panel")
  3. Remove the passenger side spray hose (A).
  4. Disconnect the connector (A), then remove the blower resistor (B) after loosening the mounting screws.
  5. To install, perform the removal procedure in reverse order.

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.