Hyundai Tucson LM Quiz
Body (Interior and Exterior)

Console Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 1Engine Mechanical System — 44Engine Electrical System — 45Emission Control System — 24Engine Control System/Fuel System — 93Clutch System — 13Manual Transmission — 18Automatic Transmission — 87Four-Wheel Drive (4WD) System — 26Drive Shaft and Axle — 29Suspension System — 35Steering — 20Restraints — 47Brake System — 36Body (Interior and Exterior) — 53Body Electrical System — 202Heating, Ventilation, and Air Conditioning — 58
20steps
~120min
4/5difficulty
Done 0 of 20

Replacement

[M/T]
  • Wear gloves to protect your hands.
  • Using a flat-tip screwdriver, wrap protective tape around the tip and apply protective tape around the relevant parts to prevent damage.
  • Use a plastic panel removal tool to remove the interior trim parts so as not to damage the surface.
  • Be careful not to bend or scratch the trim and panels.
  1. Using a screwdriver, remove the knob (A) and boots (B).
  2. Using a screwdriver, remove the floor console tray (A).
  3. Using a screwdriver, remove the floor console front panel (A).
  4. Disconnect the connectors (A).
  5. Using a screwdriver, remove the console upper cover (A).
  6. Disconnect the connector (A).
  7. Remove the console tray mat (A).
  8. Remove the console extension side cover (A).
  9. After loosening the mounting bolts and screws, remove the floor console assembly (A).

[A/T]
  • Wear gloves to protect your hands.
  • Using a flat-tip screwdriver, wrap protective tape around the tip and apply protective tape around the relevant parts to prevent damage.
  • Use a plastic panel removal tool to remove the interior trim parts so as not to damage the surface.
  • Be careful not to bend or scratch the trim and panels.
  1. Remove the knob (A).
  2. Using a screwdriver, remove the floor console tray (A).
  3. Using a screwdriver, remove the floor console front panel (A).
  4. Disconnect the connectors (A).
  5. Using a screwdriver, remove the console upper cover (A).
  6. Disconnect the connector (A).
  7. Remove the console armrest (A).
  8. Remove the console tray mat (A).
  9. Remove the console extension side cover (A).
  10. After loosening the mounting bolts and screws, remove the floor console assembly (A).
  11. Install in the reverse order of removal.
    • Make sure the connector is properly connected.
    • Replace any damaged clips.

Test yourself

A quick Hyundai Tucson LM quiz: every answer comes with an explanation and a link to the manual page.