Hyundai Tucson LM Quiz
Body (Interior and Exterior)

Roof Trim Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 1Engine Mechanical System — 44Engine Electrical System — 45Emission Control System — 24Engine Control System/Fuel System — 93Clutch System — 13Manual Transmission — 18Automatic Transmission — 87Four-Wheel Drive (4WD) System — 26Drive Shaft and Axle — 29Suspension System — 35Steering — 20Restraints — 47Brake System — 36Body (Interior and Exterior) — 53Body Electrical System — 202Heating, Ventilation, and Air Conditioning — 58
23steps
~138min
4/5difficulty
Done 0 of 23

Replacement

Sun Visor Replacement
  1. Loosen the mounting screws, then remove the sun visor (A) and clip (B).
  2. Install in the reverse order of removal.
  3. Remove the covers (A), then remove the screws and the assist grip (B).
  4. Install in the reverse order of removal.
  5. Loosen the mounting screws, then remove the overhead console assembly (A).
  6. Press the lock pin (A), then disconnect the connectors (B).
  7. Install in the reverse order of removal.
    • Make sure the connector is properly connected.
  8. Using a screwdriver, remove the cover (A).
  9. Loosen the mounting screws, then remove the room lamp (B).
  10. Disconnect the connector (C).
  11. Install in the reverse order of removal.
    • Make sure the connector is properly connected.
  12. Using a screwdriver, remove the vanity lamp (A).
  13. Disconnect the connector (B).
  14. Install in the reverse order of removal.
Assist Grip Replacement, Overhead Console Replacement, Room Lamp Replacement, Vanity Lamp Replacement, Roof Trim Assembly Replacement
  • Wear gloves to protect your hands.
  • Using a flat-tip screwdriver wrapped with protective tape to prevent damage, pry carefully.
  • Be careful not to bend or scratch the trim and panels.
  1. Remove the following items.
    A. Sun visor.
    B. Overhead console.
    C. Room lamp.
    D. Assist grip.
  2. Disconnect the cover (A) and the ECM room mirror connector (B).
  3. Disconnect the cover (A) and the rain sensor connector (B).
  4. Disconnect the wiring connector (A) and the mounting clips. [Driver]
    [Passenger]
  5. Insert the lower clip (A) of the second row seat belt into the second row center seat belt cover.
  6. Disconnect the antenna connector (A).
  7. Disconnect the connector (B).
  8. Release the clips and remove the headliner (A).
  9. Install in the reverse order of removal.
    • Replace any damaged clips.

Test yourself

A quick Hyundai Tucson LM quiz: every answer comes with an explanation and a link to the manual page.