Rear Shock Absorber Repair Procedures

Replacement

1. 1
   Remove the rear wheel and tire.

   Tightening torque: 88.3 ~ 108 N·m

   Be careful not to damage the hub bolts when removing the rear wheel and tire.

2. 2
   Loosen the bolt and nut, then disconnect the shock absorber (A) from the rear axle.

   Tightening torque: 137.3 - 157 N·m N·m (14.0 - 16.0 kgf·m, 101.3 - 115.7 ft-lbf)

   

3. 3
   Loosen the shock absorber mounting bolts (A).

   Tightening Torque: 49.0 ~ 64 N·m

   

4. 4
   Installation is the reverse of removal.

Inspection

1. 1
   Inspect the rubber components for damage or wear.
2. 2
   Check the shock absorber for abnormal resistance or unusual noise.
3. 3
   Fully extend the shock absorber piston rod.
4. 4
   Drill a hole to release the gas from the cylinder.

   

   The escaping gas is harmless, but be careful of chips that may fly off when drilling. Be sure to wear a protective mask and safety glasses.