Hyundai Tucson LM Quiz
Suspension System

Rear Stabilizer Bar Repair Procedures

In this manual: Suspension System
General Information — 1Engine Mechanical System — 44Engine Electrical System — 45Emission Control System — 24Engine Control System/Fuel System — 93Clutch System — 13Manual Transmission — 18Automatic Transmission — 87Four-Wheel Drive (4WD) System — 26Drive Shaft and Axle — 29Suspension System — 35Steering — 20Restraints — 47Brake System — 36Body (Interior and Exterior) — 53Body Electrical System — 202Heating, Ventilation, and Air Conditioning — 58
6steps
~36min
2/5difficulty
04080120160200107.980N·mlb·ft
Tightening torque found on this page
Done 0 of 6

Replacement

  1. Remove the rear wheel and tire.

    Tightening torque: 88.3 ~ 108 N·m
    Be careful not to damage the hub bolts when removing the rear wheel and tire.
  2. Loosen the nut and remove the rear stabilizer link (B) from the rear lower arm (A).

    Tightening torque: 98.1 ~ 118 N·m

    [4WD]
    [2WD]
  3. Loosen the mounting bolt and remove the stabilizer bar (A) from the subframe.

    Tightening torque: 44.1 ~ 54 N·m

    [4WD]
    [2WD]
  4. Installation is the reverse of removal.

Inspection

  1. Check the rear stabilizer bar for deformation.
  2. Check the ball joint of the rear stabilizer link for damage.

Test yourself

A quick Hyundai Tucson LM quiz: every answer comes with an explanation and a link to the manual page.