Rear Turn Signal Light Bulb Replacement

• Remove the upper seat cover (see Seat Cover Removal in the Frame chapter).
• Disconnect the tail/brake light connector [A].

• Turn the socket [A] counterclockwise and remove the socket together with the bulb.

• Push and turn the turn signal light bulb [A] counterclockwise and remove it.
• Replace the bulb with a new one.

• Insert the new bulb [A] by aligning its pins [B] with the grooves [C] in the socket, and turn the bulb clockwise securely.

• Fit the tabs [A] of the socket into the grooves [B] of the turn signal light housing.
• Turn the socket clockwise.

Another Bulb: Repeat the above steps.

US, CA and CAL Models

• Remove: Screw [A] Rear Turn Signal Light Lens [B]

• Push and turn the turn signal light bulb [A] counterclockwise and remove it.
• Replace the bulb with a new one.

• Insert the new bulb [A] by aligning its pins [B] with the grooves [C] in the socket, and turn the bulb clockwise securely.

• Install the lens [A].

Check that the “R” (Right) or “L” (Left) mark [B].

• Tighten: Torque - Rear Turn Signal Light Lens Screws: 1.0 NВ·m(0.10 kgfВ·m, 8.9 inВ·lb)

Another Bulb: Repeat the above steps.