Kawasaki Ninja ZX-10R Quiz
Self-Diagnosis System

Service Code Reading

In this manual: Self-Diagnosis System
General Information — 26Periodic Maintenance — 66Fuel System (DFI) — 79Cooling System — 28Engine Top End — 51Clutch — 24Engine Lubrication System — 28Engine Removal/Installation — 5Crankshaft/Transmission — 65Wheels/Tires — 22Final Drive — 17Brakes — 54Suspension — 36Steering — 17Frame — 40Electrical System — 104Self-Diagnosis System — 112Appendix — 10
~1min read

The service code(s) is displayed on the LCD by the number of two digits.

NOTE

  • The service code of the KIBS and ABS adds “b” at the left side of the code.
  • The service code of the ESD adds “E” at the left side of the code.
Service Code Reading

  • When there are a number of problems, all the service codes can be stored and the display will begin starting from the lowest number service code in the numerical order.
  • Then after completing all codes, the display is repeated until the ignition switch is turned to OFF or upper button and lower button are pushed for more than two seconds.
  • The order of the system’s appearing is the order of DFI System, Immobilizer System (equipped models), S-KTRC System, KIBS and ABS (equipped models), and ESD System (ZX1000JD/KD).
  • For example, if three problems occurred in the order of 46, 16, 33, the service codes are displayed (each two seconds) from the lowest number in the order listed as shown below.

(16 → 33 → 46) → (16 → 33 → 46) → → В·В·В·В·В· (repeated)

  • If the no problem or when the repair has been done, warning indicator light (LED) and warning symbol go off and service code is not displayed.

Test yourself

A quick Kawasaki Ninja ZX-10R quiz: every answer comes with an explanation and a link to the manual page.