Rear Wheel Rotation Sensor Signal (Service Code 24)

Rear Wheel Rotation Sensor Signal Inspection

The rear wheel rotation sensor sends the signal to the ECU through the KIBS hydraulic unit (KIBS equipped models). For other than KIBS equipped models, the signal is sent directly to the ECU.

The ECU uses the rear wheel rotation sensor signal for motorcycle speed and S-KTRC control.

The service code 24 is detected with the ECU.

• When the service code 24 and following service codes (for KIBS) are displayed at the same time, inspect the rear wheel rotation sensor.

Service Code b 44 (see Rear Wheel Rotation Sensor Signal Abnormal) Service Code b 45 (see Rear Wheel Rotation Sensor Wiring Inspection)

When only service code 24 is displayed, do the following inspection procedures.

Disconnect: ECU Connectors (see ECU Removal in the Fuel System (DFI) chapter) Front and Rear Wheel Rotation Sensor Lead Connectors KIBS Hydraulic Unit Connector (see KIBS Hydraulic Unit Removal in the Brakes chapter)

For KIBS equipped models, check the wiring for continuity between harness connectors.

Special Tool - Hand Tester: 57001-1394

Wiring Continuity Inspection ECU Connector [A] ← → KIBS Hydraulic Unit Connector [B] R/Y lead (ECU terminal 34, KIBS Hydraulic Unit terminal 16) [C]

Wiring Continuity Inspection KIBS Hydraulic Unit Connector [A] ← → Rear Wheel Rotation Sensor Connector [B] G lead (KIBS Hydraulic Unit Connector terminal 14) [C] R lead (KIBS Hydraulic Unit Connector terminal 13) [D]

• For other than KIBS equipped models, check the wiring for continuity between harness connectors and resistance.

Special Tool - Hand Tester: 57001-1394

Wiring Continuity Inspection ECU Connector [A] ← → Rear Wheel Rotation Sensor Connector [B] R lead (ECU terminal 58) [C] R/Y lead (ECU terminal 34) [D]

Rear Resistor Resistance (in Main Harness) Connections: ECU Connector [A] ← → Ground [B] R/Y lead (ECU terminal 34) [C] Standard: 209 231 Ω

If the resistance is out of the standard, replace the main harness.

If the wiring and resistance are good, check the ECU for its ground and power supply (see ECU Power Supply Inspection in the Fuel System (DFI) chapter).

If the ground and power supply are good, replace the ECU (see ECU Removal/Installation in the Fuel System (DFI) chapter).

Wheel Rotation Sensor Circuit (KIBS Equipped Models)

1. ECU

2. Front Wheel Rotation Sensor

3. KIBS Hydraulic Unit

4. Rear Wheel Rotation Sensor

Wheel Rotation Sensor Circuit (other than KIBS Equipped Models)

1. ECU

2. Front Wheel Rotation Sensor

3. Resistor F 220 Ω

4. Resistor R 220 Ω

5. Frame Ground 3

6. Rear Wheel Rotation Sensor