Curtain Airbag (CAB) Module Repair Procedures

Removal

1. 1
   Disconnect the negative battery cable and wait at least thirty seconds before starting work.
2. 2
   Remove the roof headlining. (Refer to Body - "Roof Headlining Assembly")
3. 3
   Disconnect the curtain airbag harness connector (A).

   

4. 4
   After loosening the mounting bolts and nuts, remove the curtain airbag.

Installation

1. 1
   Remove the ignition key from the vehicle.
2. 2
   Disconnect the negative battery cable and wait at least thirty seconds.
3. 3
   Tighten the curtain airbag bolts and nuts. Tightening torque: Bolts: 9.8 ~ 14.7 N·m Nuts: 7.8 ~ 11.8 N·m

   Never twist the airbag module during installation. If the module is twisted, the airbag module may not operate correctly.

4. 4
   Connect the curtain airbag connector.
5. 5
   Install the roof trim. (Refer to Body - "Roof Trim Assembly")
6. 6
   Connect the negative battery cable.
7. 7
   After installing the curtain airbag (CAB), check that the system operates correctly:

   • Turn the ignition ON; the SRS indicator should illuminate for approximately six seconds, then turn off.