Repair Procedures of Passenger Airbag (PAB) Module

Removal

1. 1
   Disconnect the negative battery cable and wait at least thirty seconds before starting work.
2. 2
   Remove the glove box housing. (Refer to Body - "Glove Box Housing")
3. 3
   Loosen the passenger airbag mounting bolts (A).

   

4. 4
   Disconnect the front passenger airbag connector (A) and the active ventilation connector (B).

   

5. 5
   Remove the emergency airbag. (Refer to Body - "Main Protector Assembly")

   Replace the emergency airbag if it was damaged during PAB deployment.

6. 6
   Remove the airbag mounting bolts. Then remove the front passenger airbag.

   Store the removed airbag module in a clean, dry place with the airbag facing up.

Installation

1. 1
   Remove the ignition key from the vehicle.
2. 2
   Disconnect the negative battery cable from the battery and wait at least thirty seconds before starting work.
3. 3
   Place the front passenger airbag on the protector and tighten the front passenger airbag mounting bolts (A).

   Tightening torque: 3.9 ~ 5.9 N·m

   

4. 4
   Install the emergency airbag. (Refer to Body - "Main Protector Assembly")
5. 5
   Tighten the passenger airbag mounting bolts.

   Tightening torque: 7.8 ~ 11.8 N·m

6. 6
   Connect the passenger airbag wiring harness connector to the SRS main wiring harness connector.
7. 7
   Install the glove box housing. (Refer to Body - "Glove Box Housing")
8. 8
   Connect the negative battery cable.
9. 9
   After installing the passenger airbag (PAB), check that the system operates correctly:

   • Turn the ignition ON; the SRS indicator should illuminate for approximately six seconds, then turn off.