Kia Cadenza VG Owner's Manual Quiz
Body Electrical System

Power Window Switch Repair Procedures

In this manual: Body Electrical System
General Information — 15Engine Mechanical System — 95Engine Electrical System — 54Emission Control System — 24Engine Control System/Fuel System — 115Automatic Transmission — 91Drive Shaft and Axle — 13Suspension System — 35Steering — 19Restraints — 46Brake System — 43Body (Interior and Exterior) — 51Body Electrical System — 245Heating, Ventilation, and Air Conditioning — 56
25steps
~150min
4/5difficulty
Done 0 of 25

Inspection

Driver Window Switch
  1. To inspect the driver power window switch, select the vehicle type and the "IPM" menu.
  2. Select "DDM (Driver Door Module)".
  3. Select the "Input/Output Monitor" option.
  4. To check the input value of the power window switch in forced mode, select the "ACTUATION TEST" option.
  5. To inspect the auxiliary power window switch, select the vehicle type and the "IPM" menu.
  6. Select "ADM (Assist Door Module)".
  7. Select the "Input/Output Monitor" option.
  8. To check the input value of the power window switch in forced mode, select the "ACTUATION TEST" option.
Auxiliary Power Window Switches

Removal

Driver Window Switch

  1. Disconnect the negative (-) battery terminal.
  2. Remove the front door panel. (Refer to Body - "Front Door")
  3. Disconnect the connector (A) of the power window switch module from the wiring harness.
  4. Remove the power window switch module (A) from the door trim panel after loosening the mounting screws (13 EA).
  5. Remove the module (A) from the auxiliary box after loosening the mounting screw (3 EA).

Passenger Window Switch

  1. Disconnect the negative (-) battery terminal.
  2. Remove the rear door panel. (Refer to Body - "Rear Door")
  3. Disconnect the connector from the power window switch module.
  4. Remove the power window switch module (A) from the door trim panel after loosening the mounting screws (13 EA).
  5. Remove the module (A) from the auxiliary box after loosening the mounting screw (3 EA).

Rear Power Window Switch

  1. Disconnect the negative (-) battery terminal.
  2. Remove the rear door panel. (Refer to Body - "Rear Door")
  3. Disconnect the connector from the power window switch module.
  4. Remove the power window switch module (A) from the door trim panel after loosening the mounting screws (13 EA).
  5. Remove the module (A) from the auxiliary box assembly.

Installation

  1. Install the power window switch module.
  2. Install the door trim panel after reconnecting the related connectors.

Test yourself

A quick Kia Cadenza VG Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.