Rear Trailing Arm Repair Procedures

Replacement

1. 1
   Remove the rear wheel and tire.

   Tightening torque: 88.3 ~ 108 N·m

   Be careful not to damage the hub bolts when removing the rear wheel and tire.

2. 2
   Remove the cotter pin and castle nut, then disconnect the rear trailing arm (A) from the rear axle.

   Tightening torque: 78.5 - 88 N·m

   

3. 3
   Loosen the bolt and nut, and remove the rear assist arm (A) from the subframe.

   Tightening torque: 107.9 - 118 N·m

   

4. 4
   Installation is the reverse of removal.

Inspection

1. 1
   Inspect the bushing for wear and damage.
2. 2
   Inspect the rear lower arm for deformation.
3. 3
   Check the coil spring and spring seat for wear and deformation.
4. 4
   Check that all bolts and nuts are present.