Kia Cadenza VG Owner's Manual Quiz
Body Electrical System

Repair Procedures

In this manual: Body Electrical System
General Information — 15Engine Mechanical System — 95Engine Electrical System — 54Emission Control System — 24Engine Control System/Fuel System — 115Automatic Transmission — 91Drive Shaft and Axle — 13Suspension System — 35Steering — 19Restraints — 46Brake System — 43Body (Interior and Exterior) — 51Body Electrical System — 245Heating, Ventilation, and Air Conditioning — 56
14steps
~84min
3/5difficulty
Done 0 of 14

Inspection

Light Switch Inspection: With the combination switch in each position, make sure continuity exists between the terminals below. If continuity is not as specified, replace the combination switch.
Light Switch (Automatic Lighting)
Light Switch
Dimmer and Passing Switch
HU: High Beam HL: Low Beam P: Headlight Switch Turn Signal Switch
Front Fog Light Switch
Front and Rear Fog Light Switch
Wiper and Washer Switch Inspection: With the combination switch in each position, make sure continuity exists between the terminals below. If continuity is not as specified, replace the combination switch.
Wiper Switch
Washer Switch

Inspection (with GDS)

  1. Check the BCM input/output specification of the multifunction switch using GDS. If the specification is not normal, replace the lamp or wiper switch.
  2. If diagnosis of the multifunction switch is required, select the model and "IPM".
  3. To view the BCM input/output current data, select "Current Data". Provides information on the BCM input/output states: power, turn signal/stop lamp, headlamp, door, locks, outside mirror, wiper, auto light and transmitters, etc.
  4. To perform a forced actuation of BCM input factors, select "ACTUATION TEST".

Removal

  1. Remove the upper and lower steering column shrouds by removing the 3 screws.
  2. Disconnect the light switch connector (A) and the wiper and washer switch connector (B).
  3. If necessary, remove the wiper and washer switch (A). Release the wiper switch lock using a tool, without removing the steering wheel and clock spring.
  4. Remove the steering wheel. (Refer to Steering System - "Steering Column and Shaft")
  5. Remove the clock spring. (Refer to Restraints - "Airbag Module")
  6. Remove the multifunction switch assembly (A) after loosening the mounting screws (2 pcs).

Installation

  1. Install the multifunction switch.
  2. Install the clock spring and steering wheel.
  3. Install the upper and lower steering column covers.
  4. Install the steering wheel.

Test yourself

A quick Kia Cadenza VG Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.