Engine Electrical System

Battery Sensor Repair procedures

7steps
~42min
2/5difficulty
010203040509.87N·mlb·ft
Tightening torque found on this page
Done 0 of 7

Removal

  1. Open the trunk.

  2. Remove the luggage side trim [RH].

    (Refer to Body - "Luggage Side Trim")

  3. Turn ignition switch OFF and disconnect the battery negative (-) terminal (A).

  4. Disconnect the battery sensor connector (B).

    Battery (-) terminal tightening nut :

    7.8 - 9,8 N·m

  5. Remove the battery sensor (A) by loosening the mounting bolt (B).

    Battery sensor cable flange mounting bolt(Chassis ground) :

    10.8 - 13,7 N·m

Installation

  1. Install in the reverse order of removal.

Battery Sensor Recalibration Procedure

After reconnecting the battery negative cable, AMS function does not operates until the system is stabilized, about 4 hours. If disconnecting the negative (-) battery cable from the battery during repair work for the vehicle equipped with AMS function, Battery sensor recalibration procedure should be performed after finishing the repair work.

  1. Turn the Iginition switch ON and OFF.

  2. Park the vehicle for about 4 hours with the hood and all doors closed.