Brake System

Brake Actuation Unit Repair procedures

20steps
~120min
5/5difficulty
0102030405010.78N·mlb·ft
Tightening torque found on this page
Done 0 of 20

Removal

  1. Turn ignition switch OFF and disconnect the negative (-) battery terminal.

  2. Disconnect the TCM connector.

    (Refer to DCT (Dual Clutch Transmission) System - "DCT Control Module (TCM))

  3. Disconnect the ECM connector.

  4. Remove the air cleaner assembly.

    (Refer to Engine Mechanical System - "Air Cleaner")

  5. Remove the brake fluid from the reservoir .

  6. Remove the nuts, hose, brake fluid level sensor connector (A).

    Tightening torque: 6.8 - 10,7 N·m

  7. Disconnect the integrated brake actuation unit (IBAU) connector and brake tube.

  8. Loosen the flare nuts (A) from the integrated brake actuation unit (IBAU) and then remove the brake tube.

    Tightening torque: 12.7 - 16,7 N·m

  9. Remove the snap pin (A) and clebis pin (B).

  10. Loosen the brake pedal nuts.

    Tightening torque : 16.7 - 26 N·m

Installation

  1. Installation is the reverse of removal.

  2. Check the brake pedal operation.

  3. After filling the brake fluid in the reservoir, perform the air bleed.

    (Refer to the Brake system - "Brake Bleeding Procedure")

  4. Conduct the variant coding.

  5. Conduct the pedal traval sensor (PTS) calibration.

  6. Conduct the longitidinal G sensor clibration. (HAC/DBC Only)

  7. Conduct the pressure sensor calibration.

  8. Conduct the auto detected configuration reset the if necessary.

Diagnosis by using diagnostic device

The following section describes how to diagnose faults using a diagnostic instrument.

  1. Connect the diagnostic instrument to the self-diagnostic connector (16-pin) beneath the crash pad on the side of driver's seat, and then turn on the ignition to activate the diagnostic instrument.

  2. In the GDS vehicle type selection menu, select "Vehicle Type" and "Brake/VDC/AHB" System.

    Longitudinal G Sensor Calibration(HAC/DBC Only)

    Pressure Sensor Calibration

    Pedal Travel Sensor (PTS) Calibration

    Auto Detected Configuration Reset(ESP(ESC) Only)

    VARIANT CODIN