Hybrid Control System
Cooling Duct Repair procedures
In this manual: Hybrid Control System
8steps
~48min
4/5difficulty
Done 0 of 8
Removal
Cooling Duct (Inlet)
Shut off the high voltage circuit.
(Refer to Hybrid Control System - “High Voltage Shutoff Procedure”)
Remove the rear seat cushion.
(Refer to Body - "Rear Seat Assembly")
Remove the rear door scuff trim.
(Refer to Body - "Door Scuff Trim")
Remove the inlet cooling duct (A) after loosening the mounting fastener.

Cooling Duct (Outlet)
Shut off the high voltage circuit.
(Refer to Hybrid Control System - “High Voltage Shutoff Procedure”)
Remove the rear seat cushion.
(Refer to Body - "Rear Seat Assembly")
Remove the rear door scuff trim.
(Refer to Body - "Door Scuff Trim")
Remove the outlet cooling duct (A) after loosening the mounting nut.

Installation
Install the cooling ducts in the reverse order of removal.
Was this page helpful?