Engine Mechanical System

Cylinder Head Cover Repair procedures

14steps
~84min
3/5difficulty
0102030405023.517N·mlb·ft
Tightening torque found on this page
Done 0 of 14

Removal

Engine removal is not required for this procedure.

  1. Disconnect the negative battery terminal.

  2. Remove the air cleaner assembly.

    (Refer to Intake And Exhaust System - "Air Cleaner")

  3. Remove the high pressure fuel pump foam (A).

  4. Disconnect the fuel hose (A).

  5. Disconnect the wiring connectors and harness clamps and remove the connector brackets around the cylinder head cover.

  6. Disconnect the reservoir tank coolant hose (A) and then drain the coolant from the reservoir tank.

  7. Separate the water return & degas pipe (A).

    Tightening torque : 18.6 - 24 N·m

  8. Disconnect the positive crankcase ventilation (PCV) hose (A).

  9. Remove the high pressure fuel pump.

    (Refer to Engine Control/Fuel System - "High Pressure Fuel Pump")

  10. Remove the ignition coils.

    (Refer to Engine Electrical System - “Ignition Coil”)

  11. Disconnect the engine ground cable (A).

    Tightening torque : 10.8 - 13,7 N·m

  12. Remove the cylinder head cover (A).

Installation

  1. Install the cylinder head cover.

    1. The hardening sealant should be removed from the cylinder head cover and the gap between the timing chain cover and the cam carrier before assembling the cylinder head cover.

    2. Apply engine oil on the lip portion of the oil seal on the cover and outer surface of the spark plug pipes.

    3. Assemble within 5 minutes of applying sealant on the gap between the timing chain cover and the cam carrier.

      Bead width : 2.0 - 3.0 mm (0.08 - 0.12 in.)

      Sealant : Threebond 1217H or equivalent

    4. Install the new cylinder head cover gasket (A).

    5. Install the cylinder head cover (A) by tightening the bolts, in several passes, in the sequence shown.

      Tightening torque :

      1st step: 3.9 - 5,9 N·m

      2nd step: 7.8 - 9,8 N·m

  2. Install the remaining parts in the reverse order of removal.