Driveshaft and axle

Front Driveshaft Repair procedures

15steps
~95min
5/5difficulty
1special tools
04080120160200127.594N·mlb·ft
Tightening torque found on this page
Done 0 of 15

Removal

  1. Remove the wheel and tire.

    Tightening torque: 107.9 - 128 N·m

  2. By hammering on a chisel, unlock the driveshaft lock hub nut caulking.

  3. Remove the caulking nut (A) from the front axle.

    Tightening torque: 274.6 - 294 N·m

  4. Remove the under cover.

    (Refer to Engine Mechanical System - "Engine Room Under Cover")

  5. Remove the wheel speed sensor bolt (A).

    Tightening torque : 6.8 - 10,7 N·m

  6. Remove the wheel speed sensor bracket bolt (A).

    Tightening torque : 8.8 - 13,7 N·m

  7. Remove the caliper hose bracket bolt (A).

  8. Remove the tie rod end pin (A) and nub (B).

    Tightening torque : 78.4 - 98 N·m

  9. Remove the knuckle by using the SST (09568-34000).

  10. Remove the lower arm pin (A) and nut (B).

    Tightening torque : 78.4 - 98 N·m

  11. Remove the stabilizer link nut.

    Tightening torque : 98.0 - 118 N·m

  12. Using a plastic hammer, disconnect driveshaft from the axle hub.

  13. Remove the iner shaft bearing bracket bolt (A).

    Tightening torque : 49.0 - 64 N·m

  14. Remove the drive shaft (A).

  15. Install in the reverse order of removal.