Driveshaft and axle

TJ Joint Repair procedures

19steps
~124min
5/5difficulty
2special tools
Done 0 of 19

Replacement

  1. Remove the Front Driveshaft.

    (Refer to Driveshaft Assembly - “Front Driveshaft”)

  2. Remove the BJ circlip (B) from the TJ housing (A).

  3. Remove both boot bands from the TJ housing.

  4. Remove the TJ circlip (A).

  5. Remove the snap ring (A) from the shaft.

  6. Remove the spider assembly (B) from the driveshaft (A) using the special tool (09495-33000).

  7. Clean the spider assembly.

  8. Remove the TJ boot (A).

Inspection

  1. Check the spider assembly for roller rotation, wear or corrosion.

  2. Check the groove inside the joint case for wear or corrosion

  3. Check the TJ boots for damage and deterioration.

Installation

  1. Wrap tape around the driveshaft spline(TJ) to prevent damage to the boot.

  2. Using the alignment marks (D) made during disassembly as a guide, install the spider assembly (A) and snap ring (B) on the driveshaft splines (C).

  3. Add specified grease to the joint boot as much as it was wiped away at inspection.

  4. Install the both boot band.

  5. To control the air in the TJ boot, keep the specified distance between the boot bands when they are tightened.

    Engine Distance (L) mm (in.)
    LH side RH side
    LAMBDA 3.3 519.5 (20.4527) 530.0 (20.8661)

  6. Using the SST(09495-3K000), secure the TJ boot bands.

    Clearance (A): 2.0 mm (0.0787 in.) or less

  7. Install the Front Driveshaft.

    (Refer to Driveshaft Assembly - “Front Driveshaft”)

  8. Check the front alignment.

    (Refer to Suspension System - "Front Alignment")