Suspension System

Front Stabilizer Bar Repair procedures

20steps
~125min
5/5difficulty
1special tools
02040608010037.328N·mlb·ft
Tightening torque found on this page
Done 0 of 20

Removal

  1. Disconnect the battery negative cable.

  2. Remove the universal bolt (A).

    Tightening torque : 32.4 - 37 N·m

  3. Remove the wheel and tire.

    Tightening torque: 107.9 - 128 N·m

  4. Remove the under cover.

    (Refer to Engine Mechanical System - "Engine Room Under Cover")

  5. Remove the tie rod end pin (A) and nub (B).

    Tightening torque: 78.4 - 98 N·m

  6. Remove the knuckle by using the SST (09568-34000).

  7. Remove the lower arm pin (A) and nut (B).

    Tightening torque: 78.4 - 98 N·m

  8. Remove the stabilizer link nut.

    Tightening torque: 98.0 - 118 N·m

  9. Loosen the nuts and then remove the heat protector.

  10. Remove the hanger (A).

  11. Remove the roll rod bracket.

    (Refer to Engine Mechanical System - "Engine Mounting")

  12. Loosen the bolts (A) and (B) and then remove the coolant pipe.

    Tightening torque: 6.8 - 10,7 N·m

  13. Loosen the bolts (A,B) and nuts (C,D) and then remove the sub frame (D).

    Tightening torque:

    Bolts :

    (A) 44.1 - 54 N·m

    (B) 156.9 - 176 N·m

    Nuts :

    (C) 156.9 - 176 N·m

    (D) 44.1 - 54 N·m

  14. Loosen the bolts and then remove the gearbox heat protector.

  15. Loosen the bolts and then remove the front stabilizer bar.

    Tightening torque: 44.1 - 54 N·m

  16. Install in the reverse order of removal.

  17. Check the wheel alignment.

    (Refer to Suspension System - "Alignment")

Inspection

  1. Check the bushing for wear and deterioration.

  2. Check the front stabilizer bar for deformation.

  3. Check the front stabilizer link ball joint for damage.