Body (Interior and Exterior)

Rear Door Window Glass Repair procedures

10steps
~60min
3/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 10

Replacement

  1. Remove the rear door trim.

    (Refer to Rear Door - "Rear Door Trim")

  2. Remove the rear door belt inside weatherstrip (A).

  3. Remove the rear door belt outside weatherstrip (A).

  4. Remove the rear door delta garnish (A) after loosening the screws.

  5. Loosen the rear door channel mounting bolts & nut.

    Tightening torque : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

  6. Slightly push the rear door channel in the direction of the arrow as shown below.

  7. Remove the rear door window glass mounting hole plug (A).

  8. Carefully adjust the rear door window glass (A) until the bolts are visible, and then loosen them.

  9. Remove the window glass (B) after loosening the bolt (A).

    Tightening torque : 7.8 - 11,8 N·m

  10. Install in the reverse order of removal.