Restraint

Side Impact Sensor (SIS) Repair procedures

10steps
~60min
3/5difficulty
Done 0 of 10

Removal

Pressure side impact sensor (P-SIS)

  1. Disconnect the battery negative terminal, and wait for at least thirty seconds before beginning work.

  2. Remove the front door trim.

    (Refer to Body (Interior and Exterior) - "Front Door Trim")

  3. Remove the pressure side impact sensor (A).

  4. Loosen the side pressure sensor mounting screw, and remove the sensor (B).

    Tightening torque: 2.0 - 3.0 N.m (0.2 - 0.3 kgf.m, 1.5 - 2.2 lb-ft)

Front Gravity side impact sensor (G-SIS)

  1. Disconnect the battery negative terminal, and wait for at least thirty seconds before beginning work.

  2. It separates the center pillar trim.

    (Refer to Body - see "built-in trim")

  3. Remove the side impact sensor connector (A).

  4. Loosen the mounting bolts and remove the side impact sensor (B).

    Tightening torque: 8.0 - 10.0 N.m (0.8 - 1.0 kgf.m, 5.9 - 7.3 lb-ft)

Installation

Pressure side impact sensor (P-SIS)

  1. Install in the reverse order of removal.

  2. After replacing the side impact sensors must ensure that the system is operating normally.

Front Gravity side impact sensor (G-SIS)

  1. Install in the reverse order of removal.