SRS Control Module (SRSCM) Repair procedures
Removal
Remove the battery (-) cable.
Remove the driver's seat.
(Refer to Body-see "front-seat assembly")
Remove the front door scuff trim.
(Refer to Body - see "door scuff trim")
Remove the cowl side trim.
(Refer to Body - see "cowl side trim")
It is removing the floor console assembly.
(Refer to Body - see "Floor Console Assembly")
Fold the floor carpet (A) to backward.

Remove the clip and take off the rear heating ducts (A).

Remove the cowl cross bar and the bracket (A).

Pull the locking lever of the airbag system control module (SRSCM) connector and remove the connector (A).

Unscrew the nuts and remove the airbag system control module (A).
Tightening torque: 8.0 - 10.0N.m(0.8 - 1.0 kgf.m, 5.9 - 7.3 lb-ft)

Installation
Install in the reverse order of removal.
Variant coding
After replacing the SRSCM, the “Variant Coding” must be performed.
Variant coding Procedure
¦ On-Line type on KDS/GDS
Ignition "OFF", connect KDS/GDS.
Ignition "ON" & Engine "OFF" select vehicle name and airbag system.
Select Variant coding mode.
Follow steps on the screen as below.
1) Initial ACU Variant Coding screen

2) VIN Code entering screen

3) Variant coding's proceeding screen-1

4) Variant coding's proceeding screen-2

5) Variant coding is completed

¦ Off-line type on KDS/GDS (This can be used when not connecting to internet)
1) Initial ACU Variant Coding screen

2) ACU Coding Code entering screen

3) ACU Coding code verification screen.

4) Variant coding's proceeding screen-1

5) Variant coding's proceeding screen-2

6) Variant coding is completed
