Cruise Control Switch Repair Procedures

Removal and Installation

1. 1
   Disconnect the negative battery cable.

   Tightening Torque: 4.0 ~ 6 N·m

2. 2
   Remove the driver airbag module. (Refer to RT group - "Airbag Module")
3. 3
   Remove the steering wheel. (Refer to ST group - "Steering Column and Shaft")
4. 4
   Remove the steering wheel cover (A) after loosening the screws.

   

5. 5
   Loosen the screws on the rear side of the switch.

   

   

6. 6
   Disconnect the cruise control switch connector and remove the switch (A).

   

   Be careful not to damage the hook when removing the switch.

7. 7
   Installation is the reverse of removal.

Inspection

1. 1
   Disconnect the cruise control switch connector from the control switch.

   

2. 2
   Measure the resistance between the terminals of the control switch when each function switch is in the ON position (switch pressed).

   Function Switch	Terminal	Resistance
   CANCEL	2 - 7	180? ± 5%
   SET/-	2 - 7	330? ± 5%
   RES/+	2 - 7	550? ± 5%
   ON/OFF	2 - 7	880? ± 5%

3. 3
   If not within specification, replace the switch.
4. 4
   Connect the cruise control switch connector to the control switch.

   

5. 5
   With the ignition ON, measure the voltage between the terminals of the harness-side connector when each function switch is in the ON position (switch depressed).

   Function Switch	Terminal	Voltage
   CANCEL	2 - 7	0.67 ~ 0.86 V
   SET/-	2 - 7	1.10 ~ 1.39 V
   RES/+	2 - 7	1.59 ~ 1.97 V
   ON/OFF	2 - 7	2.13 ~ 2.56 V

6. 6
   If not within specification, inspect the control switch resistance. If the measured resistance is not within specification, replace the switch and measure the voltage again.
7. 7
   If the resistance is normal but the measured voltage is not within specification, inspect the harness and connectors between the switch and the instrument cluster.