Kia Optima Hybrid Owner's Manual Quiz
Body Electrical System

IMS Power Seat Repair Procedures

In this manual: Body Electrical System
General Information — 4Engine Mechanical System — 50Engine Electrical System — 20Emission Control System — 30Engine Control System/Fuel System — 84Automatic Transmission — 98Drive Shaft and Axle — 15Suspension System — 36Steering — 12Restraints — 50Brake System — 38Body (Interior and Exterior) — 54Body Electrical System — 233Heating, Ventilation, and Air Conditioning — 57
7steps
~42min
2/5difficulty
Done 0 of 7

Inspection

  1. Disconnect the IMS control switch connector.
  2. With the IMS control switch in each position, check that continuity exists between the terminals below. If continuity does not match the specification, replace the IMS control switch.

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the front door trim panel. (Refer to Group BD - "Front Door")
  3. After removing the mounting screws (4 pcs) and the switch connector (A), remove the IMS control switch (B) from the front door trim panel.

Installation
  • Make sure that the connectors of the IMS control switch and the corresponding connectors are connected correctly.
  • Make sure that the IMS control switch operates normally.
  1. Connect the connectors and install the IMS control switch.
  2. Install the front door trim panel.

Test yourself

A quick Kia Optima Hybrid Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.