Cut-Off Switch Repair Procedures

Inspection

1. Check the audio remote control switch for resistance between the terminals in each switch position. [Cut-off + Reset]

   

   Switch	Connector Terminal	Resistance (±5%)
   Reset	3–5 (left)	5.54 kΩ
   Trip	3–5 (left)	2.54 kΩ

   
   [Cut-off + Mute + Reset]

   

   Switch	Connector Terminal	Resistance (±5%)
   Mute	3-4	0 ?
   Travel (General Type)	2-5	2.55 kΩ
   Reset (General Type)	2-5	5.55 kΩ
   Travel (Cruise Type)	2-5	1.1 kΩ
   Reset (Cruise Type)	2-5	4.1 kΩ

   
   [Cut-off + ECO + Reset]

   

   Switch	Connector Terminal	Resistance (±5%)
   ECO	3-5	0 ?
   Travel (General Type)	2-5	2.55 kΩ
   Reset (General Type)	2-5	5.55 kΩ
   Travel (Cruise Type)	2-5	1.1 kΩ
   Reset (Cruise Type)	2-5	4.1 kΩ

Removal

1. 1
   Disconnect the negative (-) battery terminal.
2. 2
   Remove the driver airbag module. (Refer to Group RT)
3. 3
   Remove the steering wheel. (Refer to Group ST - "Steering Column and Shaft")
4. 4
   Remove the steering wheel cover (A) after loosening the screws.

   

5. 5
   Disconnect the steering wheel remote control switch connector (A) after loosening the mounting screws. [Left - Mute]

   

   

Installation

1. 1
   Assemble the steering wheel remote control switch after connecting the connector.
2. 2
   Install the steering wheel.
3. 3
   Install the driver airbag module.

   Make sure the steering wheel remote control switch and the airbag module connectors are connected correctly.