Installation of Engine and Transaxle Assembly

Install the remaining parts in the reverse order of removal. Perform the following:

• Adjust the shift cable.
• Fill the engine with engine oil.
• Fill the transmission with fluid.
• Fill the power steering fluid.
• Fill the radiator and the coolant reservoir with engine coolant.
• Set the heater control lever to the "HOT" position.
• Clean the battery terminal posts and cable clamps, then assemble.
• Inspect for fuel leaks.
• After assembling the fuel line, turn the ignition on (do not crank the engine) so the fuel pump operates for about two seconds and pressurizes the fuel line.
• Repeat this operation two or three times, then check for fuel leaks at all points of the fuel line.
• Bleed air from the cooling system.
• Start the engine and let it run until it warms up (until the radiator fan cycles 3 or 4 times).
• Turn the engine off. Check the radiator level and add coolant if necessary. This allows air trapped in the cooling system to be removed.