Floor Console Assembly Repair Procedures

Replacement

Wear gloves to protect your hands.

Using a flat-tip screwdriver, wrap protective tape around the tip and apply protective tape around the relevant parts to prevent damage. Use a plastic panel removal tool to remove the interior trim parts so as not to damage the surface. Be careful not to bend or scratch the trim and panels.

1. 1
   Pull the shift lever knob in the direction of the arrow and remove it.

   Breakaway force: 55 ± 10 kgf

   

2. 2
   Using a screwdriver or remover, remove the console upper cover (A).

   

3. 3
   Disconnect the indicator connector (A), the start/stop button switch connector (B), and the multimedia connector (C).

   

4. 4
   Press the lock pin and disconnect the EPB connector.

   

5. 5
   Remove the hole cover (A).

   

6. 6
   Remove the console side cover (A) by sliding it rearward. [LH]

   

   During installation, insert the front part of the console side cover (B) into the hook (A).

   [RH]

   

   During installation, insert the front part of the console side cover (B) into the hole (A).

7. 7
   Loosen the mounting screws and bolts, then remove the floor console assembly (A).

   

8. 8
   Install in the reverse order of removal.

   Make sure the connectors are connected correctly. Replace all damaged clips.