Rear Shock Absorber Repair Procedures

Replacement

1. 1
   Loosen the wheel nuts slightly. Raise the vehicle and make sure it is securely supported.
2. 2
   Remove the front wheel and tire (A) from the front hub.

   Tightening torque: 88.2 ~ 108 N·m

   

   Be careful not to damage the hub bolts when removing the rear wheel and tire (A).

3. 3
   Loosen the upper mounting bolt of the rear shock absorber (A).

   Tightening Torque: 49.0 ~ 64 N·m

   

4. 4
   Loosen the bolt and remove the rear shock absorber (A) from the torsion beam axle.

   Tightening torque: 98.1 ~ 118 N·m

   

Inspection

1. 1
   Inspect the rubber components for wear and deterioration.
2. 2
   Compress and extend the piston rod (A) and make sure there is no abnormal resistance or unusual noise during operation.

   

3. 3
   Fully extend the piston rod.
4. 4
   Drill a hole in the section (A) to release the gas from the cylinder.

   

   The escaping gas is harmless, but be careful of chips that may fly off while drilling.