Kia Soul EV Owner's Manual Quiz
Body Electrical System

Speaker Repair Procedures

In this manual: Body Electrical System
General Information — 17Maintenance — 17Drive Shaft and Axle — 15Suspension System — 36Steering — 24Restraints — 48Brake System — 37Body (Interior and Exterior) — 207Body Electrical System — 203Heating, Ventilation, and Air Conditioning — 80Electric Vehicle Battery System — 115
13steps
~78min
3/5difficulty
Done 0 of 13

Inspection

  1. Speaker Troubleshooting
    1. Basic Speaker Inspection: Check the speaker sound, making sure the speaker mounting screws are removed and the wiring connector is connected securely to eliminate vibration transmitted from the body trim and surrounding parts.
    2. Troubleshooting by Symptom
      No. Symptom Inspection/Remedy
      1 Rattling Noise
      1. Before replacing the speaker, make sure the mounting screws are installed correctly.
      2. After reinstalling the speaker, make sure there is no rattling noise.
      3. If the rattling noise occurs again, replace the speaker with a new one.
      2 Noise
      1. Check that the wiring connector is connected correctly. If not, connect the wiring connector.
      2. If noise is heard when the radio is turned on, replace the speaker with a new one.
      3 Poor Performance Check the wiring connection between the battery and the speaker
      1. Before replacing the speaker, check the wiring and connections in the speaker circuit.
      2. Check the power supply to the speaker and the resistance, then check the sound quality.
      3. If the speaker performs poorly, replace it with a new one.

      When handling the speaker:
      • Dropping or rough handling of the speaker may damage it.
      • Be careful not to spill water or oil on the speaker.
      • Be careful when handling speakers, as the diaphragm is made of paper and can easily tear from impact or external force.
      • Improper handling of electrical speakers is not covered by the manufacturer's warranty.

Removal
Wear gloves to protect your hands.
  • Using a flat-tip screwdriver, wrap protective tape around the tip and apply protective tape around the relevant parts to prevent damage.
  • Use a plastic panel removal tool to remove the interior trim parts so as not to damage the surface.
  • Be careful not to bend or scratch the trim and panels.
Front Speaker
  1. Remove the front door trim panel. (Refer to Body - "Front Door Trim")
  2. Remove the front speaker (A) after loosening the screws.
  3. Remove the rear door trim panel. (Refer to Body - "Rear Door Trim")
  4. Remove the rear speaker (A) after loosening the screws.
  5. Using a screwdriver or remover (A), remove the speaker grille (B) from the side vent.
  6. Separate the tweeter (A) after loosening the mounting screws.
  7. Remove the tweeter (B) after disconnecting the connector (A).
Rear Speaker Tweeter Speaker

Installation

Front Speaker
  1. Install the front speaker.
  2. Install the front door trim panel.
  3. Install the rear speaker.
  4. Install the rear door trim panel.
  5. Connect the connector.
  6. Install the tweeter and the tweeter grille.
Rear Speaker Tweeter Speaker

Test yourself

A quick Kia Soul EV Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.