Kia Cee'd Quiz
Suspension System

Rear Trailing Arm Repair Procedures

In this manual: Suspension System
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
9steps
~59min
4/5difficulty
1special tools
04080120160200107.880N·mlb·ft
Tightening torque found on this page
Done 0 of 9

Replacement

  1. Loosen the wheel nuts slightly. Raise the vehicle and make sure it is securely supported.
  2. Remove the rear wheel and tire (A) from the rear hub.

    Tightening torque: 88.2 - 108 N·m

  3. Remove the rear shock absorber. (Refer to Rear Suspension System - "Rear Shock Absorber").
  4. Remove the cotter pin and castle nut, then disconnect the rear auxiliary arm (A) from the rear axle.

    Tightening torque: 44.1 ~ 55 N·m

  5. Using SST (09568-4A000), disconnect the auxiliary arm (A) from the carrier assembly.
  6. Loosen the bolt and nut, then remove the rear auxiliary arm (A) from the subframe.

    Tightening torque: 107.9 - 118 N·m

  7. Install in the reverse order of removal.

Inspection

  1. Inspect the bushing for wear and damage.
  2. Check that all bolts and nuts are present.

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.