Rear Shock Absorber Repair Procedures

Replacement

1. 1
   Slightly loosen the wheel nuts. Raise the vehicle and make sure it is securely supported.
2. 2
   Remove the rear wheel and tire (A) from the rear hub.

   Tightening torque: 88.2 - 108 N·m

   

3. 3
   Loosen the bolt and nut, then disconnect the shock absorber (A) from the rear axle.

   Tightening torque: 137.3 ~ 157 N·m (14.0 ~ 16.0 kgf·m, 101.3 ~ 115.7 lbf·ft)

   

4. 4
   Loosen the mounting bolts and remove the shock absorber (A).

   Tightening torque: 49.0 ~ 64 N·m

   

5. 5
   Install in the reverse order of removal.

Inspection

1. 1
   Inspect the rubber components for wear and deterioration.
2. 2
   Compress and extend the piston rod (A) and check for abnormal resistance or unusual noise during operation.

   

3. 3
   Fully extend the piston rod.
4. 4
   Drill a hole in the section (A) to release the gas from the cylinder.