Kia Cee'd Quiz
Engine Mechanical System

Rear Oil Seal Repair Procedures

In this manual: Engine Mechanical System
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
8steps
~58min
4/5difficulty
2special tools
Done 0 of 8

Removal

  1. Remove the transaxle assembly. (Refer to Manual Transaxle System - Manual Transaxle)
  2. MT: Remove the flywheel. (Refer to Cylinder Block - "Flywheel")
  3. AT: Remove the drive plate. (Refer to Cylinder Block - "Drive Plate")
  4. Remove the rear oil seal (A).

Installation

  1. Install the rear oil seal.
    1. Apply engine oil to the lip of the new oil seal.
    2. Using the SST (09231-H1100, 09231-2B200) and a hammer, drive in the oil seal until its surface is flush with the rear oil seal retainer edge.
  2. MT: Install the flywheel. (Refer to Cylinder Block - "Flywheel")
  3. AT: Install the drive plate. (Refer to Cylinder Block - "Drive Plate")
  4. Install the transaxle assembly. (Refer to Manual Transaxle System - Manual Transaxle)

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.