Repair Procedures

Removal

1. 1
   Separate the pushrod (C) after removing the pin (A) and washer (B).

   

2. 2
   Remove the battery and battery tray. G 1.6 MPI (See Engine Electrical System - Battery) G 1.4 MPI (See Engine Electrical System - Battery) D 1.6 TCI-U2 (See Engine Electrical System - Battery) D 1.4 TCI-U2 (See Engine Electrical System - Battery) G 1.6 GDI (See Engine Electrical System - Battery) G 1.6 T-GDI (See Engine Electrical System - Battery)
3. 3
   Remove the ECM. G 1.6 MPI (See Engine Control/Fuel System - Engine Control Module) G 1.4 MPI (See Engine Control/Fuel System - Engine Control Module) D 1.6 TCI-U2 (See Engine Control/Fuel System - Engine Control Module) D 1.4 TCI-U2 (See Engine Control/Fuel System - Engine Control Module) G 1.6 GDI (See Engine Control/Fuel System - Engine Control Module) G 1.6 T-GDI (See Engine Control/Fuel System - Engine Control Module)
4. 4
   For vehicles with a diesel engine, remove the fuel filter. D 1.6 TCI-U2 (See Engine Control/Fuel System - Fuel Filter) D 1.4 TCI-U2 (See Engine Control/Fuel System - Fuel Filter)
5. 5
   Disconnect the clutch tube (B) and reservoir hose (A) from the clutch master cylinder.[Gasoline]

   

   [Diesel]

   

6. 6
   Remove the master cylinder (A) by turning it clockwise.

   

Installation

1. 1
   Install in the reverse order of removal.
2. 2
   After installation, perform the air bleeding procedure for the clutch release cylinder after filling with brake fluid. (See Clutch System - Clutch Release Cylinder)