Kia Cee'd Quiz
Clutch System

Repair Procedures

In this manual: Clutch System
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
9steps
~54min
2/5difficulty
0102030405026.520N·mlb·ft
Tightening torque found on this page
Done 0 of 9

Removal

  1. Remove the transaxle assembly. G 1.6 MPI (Refer to Manual Transaxle System - "Manual Transaxle") G 1.4 MPI (Refer to Manual Transaxle System - "Manual Transaxle") D 1.6 TCI-U2 (Refer to Manual Transaxle System - "Manual Transaxle") D 1.4 TCI-U2 (Refer to Manual Transaxle System - "Manual Transaxle") G 1.6 GDI (Refer to Manual Transaxle System - "Manual Transaxle") G 1.6 T-GDI (Refer to Manual Transaxle System - "Manual Transaxle")
  2. Remove the concentric slave cylinder assembly from the transaxle case by removing the bolts (A).

    Torque: 19.6 ~ 26 N·m

Installation

  1. Installation is the reverse of removal.
  2. After filling with brake fluid, perform the air bleeding procedure for the concentric slave cylinder. (See Concentric Slave Cylinder Assembly - Adjustment)

Adjustment

Concentric Slave Cylinder Air Bleeding Procedure

  1. After removing the cap from the concentric slave cylinder bleeder, insert a vinyl hose onto the bleeder nipple.
  2. Fill the reservoir tank with the specified fluid.
  3. Depress the clutch pedal approximately 10 times.
  4. With the clutch pedal depressed, loosen the bleeder screw (A) to allow air to escape from the clutch system. Then tighten the bleeder screw.
  5. Repeat steps 2 to 4 until there are no air bubbles in the fluid.

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.