Additional Service When Replacing Transfer Control Unit
Description
When replacing transfer control unit, the following work is required. For the work procedure, refer to Work Procedure.
WORK AFTER REPLACEMENT
Unit parameter writing
Initial calibration
Work Procedure
WRITING THE REQUIRED INFORMATION FOR CONTROL UNIT REPLACEMENT
With CONSULT
Ignition switch ON.
Select "AWD/4WD".
Select "Replace ECU".
Perform the work according to the procedure displayed in CONSULT.
Ignition switch ON.
All electric loads are OFF
Brake pedal is not depressed.
Battery voltage: 12-13.5 V (Be sure to check the value of battery voltage by CONSULT.)
GO TO 2.
WRITING UNIT PARAMETER
Perform writing of the unit parameter to transfer control unit. Refer to Work Procedure.
>>GO TO 3.
INITIAL CALIBRATION
Continue the following condition.
Transmission position : P
4WD mode : AUTO
Depress the brake pedal.
Start the engine and wait for approximately 10 seconds under the brake pedal depressed.
GO TO 4.
PERFORM SELF-DIAGNOSIS
With CONSULT
Erase self-diagnostic results for “AWD/4WD”.
Ignition switch ON to OFF.
Depress the brake pedal.
Start the engine.
Perform self-diagnosis for “AWD/4WD”.
Is any DTCs detected?
YES>>Check DTC detected item. Refer to DTC Index.
NO>>WORK END