Transmission & Driveline
Rear Oil Seal
In this manual: Transmission & Driveline
~1min read
Exploded View

| O-ring | Rear companion flange | Rear oil seal | |||
| Transfer assembly | |||||
| : N·m (kg-m, ft-lb) | |||||
| : Always replace after every disassembly. | |||||
| : Apply transfer fluid. | |||||
Removal and Installation
REMOVAL
Remove the drain plug to drain the transfer fluid. Refer to Draining.
Remove the rear propeller shaft. Refer to Removal and Installation.
Remove main muffler. Refer to EXHAUST SYSTEM : Removal & Installation.
Remove the rear companion flange
and remove the o-ring.

Remove the rear oil seal.
INSTALLATION
Install rear oil seal with a drift (A) (commercial service tool) within the dimension (L) shown as follows.

| L | : 3.45 – 4.55 mm (0.1358 – 0.1791 in) |
Install the o-ring and install the rear companion flange
.

Install the rear propeller shaft. Refer to Removal and Installation.
Fill with new transfer fluid. Refer to Refilling.
Inspection
INSPECTION AFTER INSTALLATION
Check fluid leakage and the fluid level. Refer to Inspection.
Was this page helpful?