Air Tank
Exploded View

| Bracket | Air tank | Clip | |||
| Protector | Air connector | Air tube | |||
| To air suspension control module | |||||
| :vehicle front | |||||
| : Always replace after every disassembly. | |||||
| :N·m (kg-m, ft-lb) | |||||
| :N·m (kg-m, in-lb) | |||||
| :Apply silicone sealant. | |||||
Removal and Installation
REMOVAL
Start engine.
Turn auto height mode control switch to ON, shift the shift position to N and set to normal height.
Turn OFF the electronic air suspension function. Refer to Operation.
Stop engine.
Lift up the vehicle.
Remove protector mounting bolts and clips, and remove protector.
Remove silicone sealant
between the air connector
and air tank
.

Apply the matching mark
to the air tube
when replacing air connector
.

Loosen the air connector and perform air bleeding.
When reusing the air connector
, remove air tube
and air connector together from air tank
.

When replacing the air connector, follow the procedure below.Slide the air connector part
to direction
, and remove the part
from the air tube
.


Remove bracket mounting bolts
, and remove brakets
from air tank
.

Remove air tank from brackets.
Rmove brackets from frame.
INSTALLATION
Install bracket to frame.
Install air tank to brackets.
Install brackets
to air tank
, and install bracket mounting bolts
.

When reusing the air connector, install air tubes
and air connectors
together to air tank
.

When replaced the air connector, follow the procedure below.Install air connectors to air tank. Insert the air tube
straight into the air connector
to the marked point
which is applied when removing.

Apply silicone sealant to faces
air connector
and air tank
.

Start engine.
Fill the air to the air tank for 180 seconds using CONSULT. Refer to Work Support.
Stop engine.
Install protector, and install mounting bolts and clips.
Lift down the vehicle.
Start engine.
Perform pressure measurements using CONSULT. Refer to Work Support.
Use CONSULT and vehicle to the normal height. Refer to Work Support.
Turn ON the electronic air suspension function. Refer to Operation.
Stop engine.
Perform inspection after installation. Refer to Inspection.
Inspection
INSPECTION AFTER INSTALLATION
Make sure the electronic air suspension function is turn ON. Refer to Operation.
Confirm that no warning message is displayed on the information display. Refer to Air suspension warning.
Perform the self-diagnosis using CONSULT. Check if any DTC is detected. Refer to CONSULT Function.
Confirm to close the hood.
Always check for the air leakage with soapy water.