Suspension

Front Height Sensor

~1min read

Exploded View

Front height sensor
:vehicle front
:N·m (kg-m, ft-lb)
:N·m (kg-m, in-lb)

Removal and Installation

REMOVAL

Start engine.

Turn auto height mode control switch to ON, shift the shift position to N and set to normal height.

Turn OFF the electronic air suspension function. Refer to Operation.

Stop engine.

Lift up the vehicle.

Disconnect front height sensor harness connector.

Remove front height sensor.

INSTALLATION

Note the following, and install in the reverse order of the removal.

  • Completely engage hooks on frame when installing front height sensor.

  • Perform inspection after installation. Refer to Inspection.

  • Perform adjustment after installation. Refer to Adjustment.

Inspection

INSPECTION AFTER INSTALLATION

  • Make sure the electronic air suspension function is turn ON. Refer to Operation.

  • Confirm that no warning message is displayed on the information display. Refer to Air suspension warning.

  • Perform the self-diagnosis using CONSULT. Check if any DTC is detected. Refer to CONSULT Function.

  • Confirm to close the hood.

Adjustment

ADJUSTMENT AFTER INSTALLATION

Perform the height sensor calibration. Refer to Work Support.