Brakes

Brake Pedal

~2min read

Inspection and Adjustment

INSPECTION

Brake Pedal Height

Check the height (H1) between the floor panel and the brake pedal upper surface.

H1 : Refer to Brake Pedal.

Stop Lamp Switch

Check the clearance (A) among the brake pedal lever and the stop lamp switch mounting bracket .

A : Refer to Brake Pedal.

Brake Pedal Play

Press the brake pedal. Check the brake pedal play (A) (stroke until fluid pressure occurs).

A : Refer to Brake Pedal.

Depressed Brake Pedal Height

Check the height between the floor panel and the brake pedal upper surface (H2) when depressing the brake pedal at 490 N (50 kg, 110 lb) while engine ON.

H2 : Refer to Brake Pedal.

ADJUSTMENT

Brake Pedal Height

Perform the following procedure when brake pedal height is not within the specified value because brake pedal height is not adjustable.

Replace brake pedal assembly when input rod length is within specified value. Refer to Inspection.

Stop Lamp Switch

Remove instrument lower panel LH. Refer to Removal and Installation.

Disconnect the harness connector from stop lamp switch.

Loosen the stop lamp switch 90 degree counterclockwise.

Install stop lamp switch , follow the procedure below.

Penetrate the clip hole of stop lamp switch mounting bracket and firmly push the direction (1) the stop lamp switch against the stop lamp switch mounting bracket .
B : About 90 degree
Turn the stop lamp switch clockwise (2) until it stops.

Depressed Brake Pedal Height

Perform the air bleeding. Refer to Work Procedure.

Check the height between the floor panel and the brake pedal upper surface (H2) when depressing the brake pedal at 490 N (50 kg, 110 lb) while engine ON.

H2 : Refer to Brake Pedal.