Brakes

Brake Pedal

~2min read

Exploded View

Stroke sensor Clevis pin Brake pedal assembly
Brake pedal pad Snap pin Stop lamp switch
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
: Apply Nissan multi-purpose Special Grease No.2 or equivalent.
: Always replace after every disassembly.

Removal and Installation

REMOVAL

Remove driver knee air bag module. Refer to Removal and Installation.

Remove BCM. Refer to Removal and Installation.

Remove fuse block (J/B).

Disconnect the stop lamp switch harness connectors.

Remove stop lamp switch , follow the procedure below.

Rotate the stop lamp switch counterclockwise (1).
A : About 90 degree
Remove the stop lamp switch toward the direction (2).

Disconnect the stroke sensor harness connector.

Remove stroke sensor if necessary.

Remove snap pin and clevis pin from clevis of electrical brake control unit .

Remove harness clip from brake pedal.

Remove the electrical brake control unit mounting nuts from brake pedal assembly. Refer to Removal & Installation.

Remove the brake pedal assembly mounting bolts, and remove brake pedal assembly.

Perform inspection after removal. Refer to Inspection.

INSTALLATION

Note the following, and install in the reverse order of removal.

  • Never reuse stop lamp switch.

  • Never reuse the clevis pin.

  • Apply the Nissan multi-purpose Special Grease No.2 or equivalent to the clevis pin and the mating faces.

  • Never impact brake pedal such as drop and interference with tools and parts.

  • Replace brake pedal when impacting brake pedal.

  • Install stop lamp switch , follow the procedure below.

    1. Penetrate the clip hole of stop lamp switch mounting bracket and firmly push the direction (1) the stop lamp switch against the stop lamp switch mounting bracket .

      B : About 90 degree
    2. Turn the stop lamp switch clockwise (2) until it stops.

  • Perform adjustment after installation. Refer to Adjustment.

  • Perform stroke sensor calibration when brake pedal assembly removed and installed, or replaced. Refer to Work Procedure.

  • Perform stroke sensor calibration when stroke sensor removed and installed, or replaced. Refer to Work Procedure.

Inspection

INSPECTION AFTER REMOVAL

Check the brake pedal assembly for bend, damage, and cracks on the welded parts. If any is found, replace brake pedal assembly.

Adjustment

ADJUSTMENT AFTER INSTALLATION

  • Adjust each item of brake pedal after installing the brake pedal assembly to the vehicle. Refer to Inspection and Adjustment.

  • Perform stroke sensor 0 point learning. Refer to Work Procedure.