Electrical & Power Control
Charging System Preliminary Inspection
In this manual: Electrical & Power Control
~1min read
Inspection Procedure
CHECK 12V BATTERY TERMINALS CONNECTION
Check if 12V battery terminals are clean and tight.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair 12V battery terminals connection.
CHECK “B” TERMINAL CONNECTION
Check if “B” terminal (alternator ground harness) is clean and tight.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair “B” terminal connection.
CHECK 12V BATTERY STATUS
Check 12V battery status. Refer to Work Flow.
Is the inspection result normal?
YES>>GO TO 4.
NO>>Replace 12V battery. Refer to Removal and Installation.
CHECK DRIVE BELT TENSION
Check drive belt tension. Refer to Inspection.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Repair as needed.
Was this page helpful?