Driver Controls
Light & Rain Sensor
In this manual: Driver Controls
~1min read
Exploded View

| Light & rain sensor | |||||
| Bracket | |||||
| : Pawl | |||||
| : vehicle front | |||||
| : Always replace after every disassembly. | |||||
Removal and Installation
REMOVAL
Remove cover. Refer to Removal and Installation.
Disconnect light & rain sensor harness connector.
Disengage light & rain sensor fixing pawls, and then peel off light & rain sensor.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
Inspection
Push ignition switch to ON position and set combination switch to AUTO.
Spray water mist toward light & rain sensor.
If front wiper does not operate, perform diagnosis of light & rain sensor. Refer to Component Function Check.
Was this page helpful?