Transmission & Driveline

Precautions

11steps
~66min
5/5difficulty
Done 0 of 11

Precautions for Removing Battery Terminal

  • When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal” described below.

  • For Nissan Armada vehicles with the 2-batteries, be sure to connect the main battery and the sub battery before turning ON the ignition switch.

  • After installing the 12V battery, always check "Self Diagnosis Result" of all ECUs and erase DTC.

HOW TO DISCONNECT 12V BATTERY TERMINAL

Disconnect 12V battery terminal according to instruction described below.

  1. Open the hood.

  2. Turn ignition switch to the ON position.

  3. Turn ignition switch to the OFF position with the driver side door opened.

  4. Get out of the vehicle and close the driver side door.

  5. Wait at least 3 minutes. For vehicle with the engine listed below, remove the battery terminal after a lapse of the specified time.

    BR08DE : 4 minutes R9N engine : 12 minutes
    BR10DE : 12 minutes V9X engine : 4 minutes
    D4D engine : 20 minutes YD25DDTi : 2 minutes
    HR09DET : 12 minutes YS23DDT : 4 minutes
    HR10DDT : 12 minutes YS23DDTT : 4 minutes
    HR10DET : 12 minutes ZD30DDTi : 60 seconds
    HR13DDT : 12 minutes ZD30DDTT : 60 seconds
    HRA2DDT : 12 minutes K9K engine : 4 minutes
    M9R engine : 4 minutes R9M engine : 4 minutes
  6. Remove 12V battery terminal.

Precaution for when Jacking and Lifting Up the Vehicle with Electronic Air Suspension System

OPERATION PROCEDURE

Jacking up or lift up using the following steps.

  1. Start engine.

  2. Turn auto height mode control switch to ON, shift the shift position to N and set to normal height.

  3. Turn OFF the electronic air suspension function. Refer to Operation.

  4. Stop engine.

  5. Jacking up or lift up.

Precaution for Electronic Air Suspension System

Service Notice or Precautions for Rear Final Drive

  • Use recommended gear oil only. Refer to Fluids and Lubricants.

  • Check for the correct installation status prior to removal or disassembly. If matching marks are required, be certain they never interfere with the function of the parts when applied.

  • Overhaul should be done in a clean work area, it is preferable to work in dustproof area.

  • Before disassembly, using steam or white gasoline, completely remove sand and mud from the exterior of the unit, preventing them from entering into the unit during disassembly or assembly.

  • Check appearance of the disassembled parts for damage, deformation, and unusual wear. Replace them with a new ones if necessary.

  • Gaskets, seals and O-rings should be replaced any time when the unit is disassembled.

  • In principle, tighten bolts or nuts gradually in several steps working diagonally from inside to outside. If tightening sequence is specified, observe it.

  • Clean and flush the parts sufficiently and blow-dry them.

  • Be careful not to damage sliding surfaces and mating surfaces.

  • When applying sealant, remove the old sealant from the mounting surface; then remove any moisture, oil, and foreign materials from the application and mounting surfaces.

  • Always use shop paper for cleaning the inside of components.

  • Never use cotton gloves or shop rags to prevent entering of lint.

  • During assembly, observe the specified tightening torque, and apply new gear oil, petroleum jelly, or multi-purpose grease as specified for each vehicle, if necessary.