Transmission & Driveline

Rear Final Drive Assembly

11steps
~66min
4/5difficulty
Done 0 of 11

Exploded View

Final drive mounting bracket Rear final drive assembly Upper stopper
Lower stopper Washer
: N·m (kg-m, ft-lb)
: Always replace after every disassembly.

Removal and Installation

REMOVAL

  1. Drain gear oil. Refer to Draining.

  2. Remove rear propeller shaft from final drive. Refer to Removal and Installation (2WD) or Refer to Removal and Installation (4WD).

  3. Remove drive shafts. Refer to Removal and Installation.

  4. Remove rear supension member stay. Refer to Removal and Installation.

  5. Remove breather hose from rear final drive assembly. Refer to Removal and Installation.

  6. Set a suitable jack to rear final drive assembly.

  7. Remove rear final drive assembly mounting nuts ( ) from final drive mounting bracket .

  8. Remove rear final drive assembly mounting bolt ( ) and remove rear final drive assembly .

  9. Remove upper stopper, lower stopper, and washer.

  10. Remove final drive mounting bracket mounting bolts and nuts ( ).

  11. Remove final drive mounting bracket mounting bolt ( ) and remove final drive mounting bracket .

INSTALLATION

Note the following, and install in the reverse order of removal.

  • For non-reusable parts, refer to Exploded View.

  • For each tightening torque, refer to Exploded View.

  • Perform inspection after installation. Refer to Inspection.

Inspection

INSPECTION AFTER INSTALLATION

Check the oil level and the oil leakage after installation. Refer to Inspection.