Transmission & Driveline
Side Oil Seal
In this manual: Transmission & Driveline
~1min read
Exploded View

| Rear final drive assembly | Side oil seal | ||||
| : vehicle front | |||||
Removal and Installation
REMOVAL
Remove rear final drive assembly. Refer to Removal and Installation.
Remove side oil seal, using side oil seal puller (A) [SST: KV10122000 (NI-53383)] and sliding hammer (B) (commercial service tool).

INSTALLATION
Note the following, and install in the reverse order of removal.
Install side oil seal until it becomes flush with the case end, using the side oil seal installer (A) [SST: KV10123000 (NI-53384)].

Perform inspection after installation. Refer to Inspection.
Inspection
INSPECTION AFTER INSTALLATION
Check the oil level and the oil leakage after installation. Refer to Inspection.
Was this page helpful?