B2098 ignition relay on stuck
Description
• IPDM E/R operates the ignition relay when it receives an ignition switch ON signal from BCM via CAN communication. • Turn the ignition relay OFF by pressing the push-button ignition switch once when the vehicle speed is 4 km/ h (2,5 mph) or less.• Turn the ignition relay OFF with the following operation when the vehicle speed is more than 4 km/h or when an abnormal condition occurs in CAN communication from the combination meter (Emergency OFF)
- Press and hold the push-button ignition switch for 2 seconds or more.- Press the push-button ignition switch 3 times within 1.5 seconds.
NOTE:
The ignition relay does not turn ON for 3 seconds after emergency OFF even if the push-button ignition switch is pressed.
DTC Logic
DTC DETECTION LOGIC

1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON.
2. Check DTC in “Self Diagnostic Result” mode of “IPDM E/R” using CONSULT-III.
Is DTC detected? YES >> Refer to PCS-31, "Diagnosis Procedure".
NO >> INSPECTION END.
Diagnosis Procedure
1.PERFORM SELF DIAGNOSIS 1. Turn the ignition switch ON. 2. Erase “Self Diagnostic Result” of IPDM E/R. 3. Turn the ignition switch OFF, and wait for 1 second or more.4. Turn the ignition switch ON. Check “Self Diagnostic Result” again.
Is DTC “B2098” displayed? YES >> Replace IPDM E/R. Refer to PCS-34, "Removal and Installation".
NO >> Refer to GI-42, "Intermittent Incident".